Pete Posted September 19, 2009 Posted September 19, 2009 this may have been discussed before but when its attatched to my siku 8280 it will not travel on transport mode as the linkage will not lift high enougth is there a method to alter this is the agartoy 7 furrow plough the same Quote
catkom3 Posted September 19, 2009 Posted September 19, 2009 It does lift high enough,it's just that the Kuhn runs on it's rear travel wheel when in transport mode,like this,it took me time to suss it out, Regards Joe. Quote
Pete Posted September 21, 2009 Author Posted September 21, 2009 yours still looks to be sat higher than mine i have about 2mm if that Quote
Tractorman810 Posted September 21, 2009 Posted September 21, 2009 try adjusting the siku adaptor on the plough pete, undo the screws tip the plough to the right position and retighten? i know it comes off as mines of in the box, and i didnt remove it :D i would say that will cure the problem Quote
catkom3 Posted September 21, 2009 Posted September 21, 2009 Just tried it on my Siku MF 8270 and it's fine,did you notice that the head stock moves / swivels / articulates on the plough body whick also lifts / lowers the plough on the linkage Regards Joe. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.