Jack390 Posted March 3, 2023 Share Posted March 3, 2023 I know this is an old thread, but looking at removing the header on mine. Do I put the flathead in the area shown in the photo ?the gap from where the header ends. Quote Link to comment Share on other sites More sharing options...
CallumC Posted March 3, 2023 Share Posted March 3, 2023 8 hours ago, Jack390 said: I know this is an old thread, but looking at removing the header on mine. Do I put the flathead in the area shown in the photo ?the gap from where the header ends. Think so. I did one years ago pto shaft needs cut aswell I think 1 Quote Link to comment Share on other sites More sharing options...
Jack390 Posted March 3, 2023 Share Posted March 3, 2023 8 minutes ago, CallumC said: Think so. I did one years ago pto shaft needs cut aswell I think Thanks, would I cut that down after or before? Quote Link to comment Share on other sites More sharing options...
CallumC Posted March 4, 2023 Share Posted March 4, 2023 14 hours ago, Jack390 said: Thanks, would I cut that down after or before? Think I cut mine before (just at the black section) 1 Quote Link to comment Share on other sites More sharing options...
Jack390 Posted June 23, 2023 Share Posted June 23, 2023 Finally had time to start this project… spent a bit of time trying to pry the header off but to no avail. Don’t want to try and apply to much force as I Don’t want to break anything. I have been pushing the screwdriver handle to the left as shown in the photo . Is this correct? Quote Link to comment Share on other sites More sharing options...
James Joe Dewar Posted June 23, 2023 Share Posted June 23, 2023 I took the Challenger version to bits many years ago, I don't think the header comes off, take those two Phillips screws out and have a wee looksee,? Regards Joe. 1 Quote Link to comment Share on other sites More sharing options...
Jack390 Posted June 23, 2023 Share Posted June 23, 2023 3 hours ago, James Joe Dewar said: I took the Challenger version to bits many years ago, I don't think the header comes off, take those two Phillips screws out and have a wee looksee,? Regards Joe. Gave those a try , that part only removes the slide for the rams for the header if that makes sense . Thanks though . 1 Quote Link to comment Share on other sites More sharing options...
Paul Palmer Posted June 23, 2023 Share Posted June 23, 2023 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.