Jump to content
  • 0

cutting and joining brass section


masseyman

Question

8 answers to this question

Recommended Posts

will a saw like that cut brass ok then dan??? mines having probs cutting plastic at the min, doesnt seem to last very long at all

i use a couple, when they are sharp i use it to cut plastic, and when its gets older i then use it on the brass the teeth dont dig in so much on the brass.  I've been using that method for a little while now

Link to comment
Share on other sites

i use a couple, when they are sharp i use it to cut plastic, and when its gets older i then use it on the brass the teeth dont dig in so much on the brass.  I've been using that method for a little while now

Just been using mine mate and you are right about it being better when it is a bit blunt, especially when in thinner brass or tubing etc

Link to comment
Share on other sites

could you make a whole trailer out of brass ?

you can if you want, but the trailer a little heavy and then the rams wont stay up if you use aerials

havent done that much scratch buildin yet but just lookin till know where does everyone buy thier brass ??? ??? :-[

i get mine from ema or any model shop stocks it,  you can also get some strip and flat from b&q

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.