kingstarsmethurst Posted December 6, 2013 Share Posted December 6, 2013 Hi, I've recently bought a Ros NH T7.270 but the seat has become loose in the cab, is there a way of accessing the cab to re fix it or should I send it back? Many thanks Tom Link to comment Share on other sites More sharing options...
bluegreen Posted December 6, 2013 Share Posted December 6, 2013 Take of rear wheels and see where the cab has been soldered under the wheel arches, cut the melted plastic off and you can release the cab no problem Link to comment Share on other sites More sharing options...
kingstarsmethurst Posted December 7, 2013 Author Share Posted December 7, 2013 Take of rear wheels and see where the cab has been soldered under the wheel arches, cut the melted plastic off and you can release the cab no problem Many thanks for help, is re fixing the cab going to be a simple job? cheers Link to comment Share on other sites More sharing options...
convo Posted December 7, 2013 Share Posted December 7, 2013 even easyer just one screw on the under side below the cab/ floor plan and the whole cab and floor plan comes off in one lump ,,then you can do what you want Link to comment Share on other sites More sharing options...
kingstarsmethurst Posted December 8, 2013 Author Share Posted December 8, 2013 even easyer just one screw on the under side below the cab/ floor plan and the whole cab and floor plan comes off in one lump ,,then you can do what you want As you said one screw and off it popped! Getting it back on was a bit tricky but all done now, many thanks for advice Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.