robertw1

try this website for scales http://jbwid.com/scalcalc.htm

what about the netting you get in fabric shops the holes are about 1mm/2mm

what kind of mesh do you need big / small?

When I was 7 I made one out of cardboard but it was mane bad but you very rarely see one on a diagram considering most arable farms have one?

Were is the digger from?

Where did you get the fuel lorry from?

great I will look out for it

nice picture I like the trailer have you made a topic on your farm

Yer I have seen those in the ''new for 2011'' section but it looked to big to be 1:50.

sorry I thing I saw a cattle lorry it looked 1:32 but i was looking at some old Britain's Lorry's underneath the stand in a box. I don't know what make it is though unfortunately.

I'll come over then shall i bring my own mineral lick!

I tend to glue sand to a block of some sort and paint it, depending on the crop depends on how big the granules are.

the sheets I get from holly loves toys (http://www.hollylovestoys.com/) are just smaller than A4 about 12x7 inches

Try this website http://www.ema-models.co. uk/

I was looking at the E.M.A website and came across some what looked to me like the plating in the bottom of sheep trailers to give them grip and i wondered whether you could stock some on Holly Loves Toys website. I think I might have seen that type of plating in milking parlours because it is easy to wash but the cows still get grip. if it is the same plastic that my school use in there vacuum former then plastic weld works with it but I suspect it is a different plastic.

Try http://www.ema-models.co.uk/index.php/moulding-casting/mould-making-products.html i found it on this topic http://www.farmtoysforum.com/index.php?option=com_wrapper&view=wrapper&Itemid=27 it looks like it sells something like what you are looking for I hope it helps

I searched the link to E.M.A and they have some really good stuff has any one had experience with the proxxon power tools?

You seem to know what you are on about and what silicon to use .Do you know if you can use normal silicon like the stuff you use in your bathroom to seal around the sink it is that i have never made a cast before .

I noticed that your layout is in a shed does it get damp in the winter or have you damp proofed it.

I think they are going to but I am not to shore if they are 1:32 or not it is just that i saw what looked like one at Toytrac.

You have made a really good job of that beef shed I envy any cow living in that.