Grassman675 Posted October 23, 2020 Share Posted October 23, 2020 Hi Everyone, Just wondering what people use for hydraulic lines on there machines to make them look more relistic? many thanks Link to comment Share on other sites More sharing options...
Janval Posted October 23, 2020 Share Posted October 23, 2020 1 hour ago, Grassman675 said: Hi Everyone, Just wondering what people use for hydraulic lines on there machines to make them look more relistic? many thanks I've got 0.5mm, 1mm and some larger tubes Edit: Don't remember what they're called atm, got large quantities on Ebay a long time ago. Cheap from China. Got loads of little boxes full of handy stuff. Link to comment Share on other sites More sharing options...
Grassman675 Posted October 23, 2020 Author Share Posted October 23, 2020 ideal what do you use for say were they conect to eachother? Link to comment Share on other sites More sharing options...
Janval Posted October 23, 2020 Share Posted October 23, 2020 Depends, brass rod for the smaller ones and for the bigger ones styrene/plastruct rods would be fine I suppose Drilling/printing with a small hole to fit the rod and then just glue it in place really. Link to comment Share on other sites More sharing options...
Question
Grassman675
Hi Everyone,
Just wondering what people use for hydraulic lines on there machines to make them look more relistic?
many thanks
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.