3m front mounted chisel plough & 3m power harrow

[Guest Fendt pwr]

Hand made 3m chisel plough working with a 3m power harrow powered by a fendt 716 vario.

[Guest Fendt pwr]

Hand made 3m chisel plough working with a 3m power harrow powered by a fendt 716 vario.

[Guest Fendt pwr]

[FB]

nice chisel plough there F passion, how did you make that one then??. Is that the old britains drill/harrow with out the drill???

[Guest Fendt pwr]

Hey fb,yes it is the old britains power harrow on the back.It's hard to say how I made that ch/plough??I just strarted on it on day and it came out like that.

[FB]

what parts did you use??

How did you get the drill off the back of the harrow??

[Guest Fendt pwr]

what parts did you use??

How did you get the drill off the back of the harrow??

I just pulled the drill off the back

the ch/plough is made from thin modeling wood.the shanks are off an old ertl ch/plough I think.

hope that helps

[Guest quangova]

I tell ya what, having a chisel plough like that on the front of the tractor would make it scrap and bark...!

[Guest Fendt pwr]

I tell ya what, having a chisel plough like that on the front of the tractor would make it scrap and bark...!

Oh ya! I'd love to drive that set up in real life going in to an old grass feild in the fall,it sure would tell the lord all about it when you fed the tractor the fat just inside the gate way. :)

[Guest Fendt pwr]

[Guest Fendt pwr]

A wee add on that took me 1 hour to make.

[JC]

Looks well FP, does it fit on to the back of the tractors ok with that additional 3 point linkage detail??

[Guest Fendt pwr]

Cheers fp

Yep it fits on the back of the new siku tractors with no problems.I thought that wee sub soiler was a good way of filling in the gap between the back wheels and the power harrow.

[FB]

what did you use to make the vertical with the holes in?. I suppose its superglued as well!? :)

[Guest Fendt pwr]

FB,it's made from plastic card about 1.5 mm thick that I cut down to size with a craft knife,and yes I glued it together.