Paul Palmer Posted September 9 Share Posted September 9 How big is the header Joe? Try looking on ebay for one, i was very lucky and on ebay came across a wiking claas header which i will use for my britains massey conversion, but they do come up Quote Link to comment Share on other sites More sharing options...
CX820Joe Posted September 9 Author Share Posted September 9 its 40' Paul. I did see you found the smaller one on ebay, I look from time to time but don't see them very often. Someone I know off Facebook got one made but said it cost about £180 - proper brass job though. Quote Link to comment Share on other sites More sharing options...
Paul Palmer Posted September 9 Share Posted September 9 22 minutes ago, CX820Joe said: its 40' Paul. I did see you found the smaller one on ebay, I look from time to time but don't see them very often. Someone I know off Facebook got one made but said it cost about £180 - proper brass job though. Hope you find one Joe Quote Link to comment Share on other sites More sharing options...
CX820Joe Posted 3 hours ago Author Share Posted 3 hours ago Got around to removing the last bit of plinth from the Horsch drill - and think the T7.300 is the right tractor for it. Hankering for my blues again so might box up the Deutzs - until I change my mind again 😂 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.